Screw pusher clamp for use with M6, M8 and 1/4-20 base plates


Product code: R-CSP

Image of R-CSP
The screw pusher clamp is used to push a part against a support structure by screwing the thumbscrew in or out to release pressure on the part. It is recommended for use on CMMs, the Equator™ gauging system, and vision and multi-sensor machines. This is a universal component suitable for thread sizes M6, M8 and ¼-20.Note: Included: socket head cap screws and washers. Replacement for old R&R part number: CSP-20

Technical table

Adjustable (mm)16
Fixture typePush clamp
Height (mm)76.2
Length (mm)76.2
Length (in)3.00
Measurement systemMultiple
Slot height (mm)44.4
Slot length (mm)44.5
ThreadMultiple
Width (mm)25.4
Width (in)1.00

Technical documentation

Image of R-CSP_pdf
R-CSP_pdf